User Manual

The Spectrum Application (RF Measurements)
R&S
®
FPL1000
382User Manual 1178.3370.02 ─ 09
Remote command:
CALCulate<n>:MARKer<m>:FUNCtion:FPEaks:SORT on page 872
Maximum Number of Peaks
Defines the maximum number of peaks to be determined and displayed.
Remote command:
CALCulate<n>:MARKer<m>:FUNCtion:FPEaks:LIST:SIZE on page 872
Peak Excursion
Defines the minimum level value by which a signal must rise or fall so that it is identi-
fied as a maximum or a minimum by the search functions.
Entries from 0 dB to 80 dB are allowed; the resolution is 0.1 dB. The default setting for
the peak excursion is 6 dB.
For Analog Modulation Analysis, the unit and value range depend on the selected
result display type.
For more information, see Chapter 7.9.4.8, "Marker Peak List", on page 379.
Remote command:
CALCulate<n>:MARKer<m>:PEXCursion on page 847
Display Marker Numbers
By default, the marker numbers are indicated in the diagram so you can find the peaks
from the list. However, for large numbers of peaks the marker numbers may decrease
readability; in this case, deactivate the marker number display.
Remote command:
CALCulate<n>:MARKer<m>:FUNCtion:FPEaks:ANNotation:LABel[:STATe]
on page 870
Export Peak List
The peak list can be exported to an ASCII file (.DAT) for analysis in an external appli-
cation.
Remote command:
MMEMory:STORe<n>:PEAK on page 942
FORMat:DEXPort:DSEParator on page 918
7.9.4.9 Deactivating All Marker Functions
Access: "Overview" > "Analysis" > "Marker Functions" > "All Functions Off"
Or: [MKR] > "All Functions Off"
All special marker functions can be deactivated in one step.
Marker Usage