User Manual

General Instrument Setup
R&S
®
FPL1000
530User Manual 1178.3370.02 ─ 09
Insert Value
Inserts a data point in the transducer line above the selected one in the "Edit Trans-
ducer" dialog box.
Delete Value
Deletes the selected data point in the "Edit Transducer" dialog box.
Shift x
Shifts the x-value of each data point horizontally by the defined shift width.
Shift y
Shifts the y-value of each data point vertically by the defined shift width.
Save
Saves the currently edited transducer line under the name defined in the "Name" field.
Remote command:
MMEMory:SELect[:ITEM]:TRANsducer:ALL on page 926
MMEMory:STORe<1|2>:STATe on page 930
Import
Opens a file selection dialog box and loads the transducer factor from the selected file
in .CSV format.
Note that a valid import file must contain a minimum of required information for the
R&S FPL1000. For details on the file format see Chapter 9.7.3, "Reference: Trans-
ducer Factor File Format", on page 531.
Remote command:
MMEMory:LOAD<n>:TFACtor on page 962
File Explorer ← Import
Opens the Microsoft Windows File Explorer.
Remote command:
not supported
Export
Opens a file selection dialog box and stores the currently displayed transducer factor to
the defined file in .CSV format.
For details on the file format see Chapter 9.7.3, "Reference: Transducer Factor File
Format", on page 531.
The transducer factor can be imported again later by the R&S FPL1000 for use in other
measurements.
Remote command:
MMEMory:STORe<n>:TFACtor on page 962
File Explorer ← Export
Opens the Microsoft Windows File Explorer.
Remote command:
not supported
Transducers