User Manual

Network and Remote Operation
R&S
®
FPL1000
571User Manual 1178.3370.02 ─ 09
Table 10-15: Meaning of the bits used in the STATus:QUEStionable:LMARgin register
Bit No. Meaning
0 LMARgin 1 FAIL
This bit is set if limit margin 1 is violated.
1 LMARgin 2 FAIL
This bit is set if limit margin 2 is violated.
2 LMARgin 3 FAIL
This bit is set if limit margin 3 is violated.
3 LMARgin 4 FAIL
This bit is set if limit margin 4 is violated.
4 LMARgin 5 FAIL
This bit is set if limit margin 5 is violated.
5 LMARgin 6 FAIL
This bit is set if limit margin 6 is violated.
6 LMARgin 7 FAIL
This bit is set if limit margin 7 is violated.
7 LMARgin 8 FAIL
This bit is set if limit margin 8 is violated.
8 to 14 Not used
15 This bit is always 0.
STATus:QUEStionable:POWer Register
The STATus:QUEStionable:POWer register contains information about possible
overload situations that may occur during operation of the R&S FPL1000. A separate
power register exists for each active channel.
You can read out the register with STATus:QUEStionable:POWer:CONDition? or
STATus:QUEStionable:POWer[:EVENt]?
Table 10-16: Meaning of the bits used in the STATus:QUEStionable:POWer register
Bit No. Meaning
0 OVERload
This bit is set if an overload occurs at the RF input, causing signal distortion but not yet causing
damage to the device.
The R&S FPL1000 displays the keyword "RF OVLD".
1 Unused
2 IF_OVerload
This bit is set if an overload occurs in the IF path.
The R&S FPL1000 displays the keyword "IF OVLD".
Remote Control Basics