User Manual

Network and Remote Operation
R&S
®
FPL1000
578User Manual 1178.3370.02 ─ 09
Language Comment
R&S FSV
R&S FSL
Notes:
●
If you select a language other than "SCPI", the GPIB address is set to 18 if it was
20 before.
●
The Start/stop frequency, reference level and number of sweep points are adapted
to the selected instrument model.
●
When you switch between remote control languages, the following settings or
changes are made:
SCPI:
The instrument performs a PRESET.
8566A/B, 8568A/B, 8594E; FSEA, FSEB, FSEM; FSEK:
– The instrument performs a PRESET.
– The following instrument settings are changed:
Table 10-20: Instrument settings for emulation of 8566A/B, 8568A/B, 8594E; FSEA, FSEB, FSEM;
FSEK instruments
Model # of Trace
Points
Start Freq. Stop Freq. Ref Level Input Coupling
8566A/B 1001 2 GHz 22 GHz 0 dBm AC
8568A/B 1001 0 Hz 1.5 GHz 0 dBm AC
8560E 601 0 Hz 2.9 GHz 0 dBm AC
8561E 601 0 Hz 6.5 GHz 0 dBm AC
8562E 601 0 Hz 13.2 GHz 0 dBm AC
8563E 601 0 Hz 26.5 GHz 0 dBm AC
8564E 601 0 Hz 40 GHz 0 dBm AC
8565E 601 0 Hz 50 GHz 0 dBm AC
8594E 401 0 Hz 3 GHz 0 dBm AC
Note: The stop frequency indicated in the table may be limited to the corresponding
frequency of the R&S FPL1000, if required.
10.3 Network and Remote Control Settings
Access: [SETUP] > "Network + Remote"
The remote commands required to define these settings are described in Chap-
ter 11.10.6, "Configuring the Network and Remote Control", on page 967.
Network and Remote Control Settings