User Manual

Network and Remote Operation
R&S
®
FPL1000
591User Manual 1178.3370.02 ─ 09
10.4 How to Set Up a Network and Remote Control
Risk of network failure
Consult your network administrator before performing the following tasks:
●
Connecting the instrument to the network
●
Configuring the network
●
Changing IP addresses
●
Exchanging hardware
Errors can affect the entire network.
Remote operation
You can operate the instrument remotely from a connected computer using SCPI com-
mands (see Chapter 10.1.2, "SCPI (Standard Commands for Programmable Instru-
ments)", on page 547). Before you send remote commands you must configure the
instrument in a LAN network or connect it to a PC via the GPIB interface as described
in Chapter 10.4.1, "How to Configure a Network", on page 591.
Remote Desktop
In production test and measurement, a common requirement is central monitoring of
the T&M instruments for remote maintenance and remote diagnostics. Equipped with
the Remote Desktop software of Windows, the R&S FPL1000 ideally meets require-
ments for use in production. The computer that is used for remote operation is called
"controller" here.
The following tasks can be performed using Remote Desktop:
●
Access to the control functions via a virtual front panel (soft front panel)
●
Printout of measurement results directly from the controller
●
Storage of measured data on the controller's hard disk
This documentation provides basic instructions on setting up the Remote Desktop for
the R&S FPL1000. For details refer to the Windows operating system documentation.
10.4.1 How to Configure a Network
A precondition for operating or monitoring the instrument remotely is that it is connec-
ted to a LAN network or a PC connected to the GPIB interface. This is described here.
How to Set Up a Network and Remote Control