User Manual

Remote Commands
R&S
®
FPL1000
618User Manual 1178.3370.02 ─ 09
SYSTem:CLOGging <State>
This command turns logging of remote commands on and off.
Parameters:
<State> ON | OFF | 1 | 0
ON | 1
Writes all remote commands that have been sent to a file.
The destination is C:
\Users\Public\Documents\Rohde-Schwarz\Analyzer\ScpiLogging\
ScpiLog.<no.>.
where <no.> is a sequential number
A new log file is started each time logging was stopped and is
restarted.
OFF | 0
*RST: 0
Manual operation: See "I/O Logging" on page 583
SYSTem:REBoot
This command reboots the instrument, including the operating system.
SYSTem:SHUTdown
This command shuts down the instrument.
11.5 Selecting the Operating Mode and Application
The following commands are required to select the operating mode or the application
and to configure a Sequencer in a remote environment.
● Selecting the Mode and Applications....................................................................618
● Performing a Sequence of Measurements............................................................622
● Programming Example: Performing a Sequence of Measurements.....................624
11.5.1 Selecting the Mode and Applications
DISPlay:ATAB................................................................................................................619
INSTrument:CREate:DUPLicate...................................................................................... 619
INSTrument:CREate[:NEW]............................................................................................ 619
INSTrument:CREate:REPLace........................................................................................ 620
INSTrument:DELete....................................................................................................... 620
INSTrument:LIST?......................................................................................................... 620
INSTrument:REName.....................................................................................................621
INSTrument[:SELect]......................................................................................................622
Selecting the Operating Mode and Application