User Manual

Remote Commands
R&S
®
FPL1000
622User Manual 1178.3370.02 ─ 09
INSTrument[:SELect] <ChannelType> | <ChannelName>
This command activates a new channel setup with the defined channel setup type, or
selects an existing channel setup with the specified name.
Also see
●
INSTrument:CREate[:NEW] on page 619
Parameters:
<ChannelType> Channel type of the new channel setup.
For a list of available channel setup types see INSTrument:
LIST? on page 620.
<ChannelName> String containing the name of the channel setup.
Example:
INST IQ
INST 'MyIQSpectrum'
Selects the channel setup named 'MyIQSpectrum' (for example
before executing further commands for that channel setup).
Manual operation: See "Spectrum" on page 80
See "I/Q Analyzer" on page 80
See "Analog Demod" on page 80
See "Noise Figure" on page 80
See "Vector Signal Analysis (VSA)" on page 80
See "Defining a channel setup" on page 82
See "New Channel Setup" on page 83
11.5.2 Performing a Sequence of Measurements
The following commands control the sequencer.
For details on the Sequencer see Chapter 6.4, "Running a Sequence of Measure-
ments", on page 83.
INITiate:SEQuencer:ABORt............................................................................................ 622
INITiate:SEQuencer:IMMediate....................................................................................... 622
INITiate:SEQuencer:MODE.............................................................................................623
SYSTem:SEQuencer......................................................................................................623
INITiate:SEQuencer:ABORt
This command stops the currently active sequence of measurements.
You can start a new sequence any time using INITiate:SEQuencer:IMMediate
on page 622.
Usage:
Event
Manual operation: See "Sequencer State" on page 86
INITiate:SEQuencer:IMMediate
This command starts a new sequence of measurements by the Sequencer.
Selecting the Operating Mode and Application