User Manual

ManualsBrandsRohde & Schwarz ManualsSignal Generators & Spectrum AnalysersSpectrum Analyser Portable, 3GHz, 50Ohm

621

622

623

624

625

626

627

628

629

630

Remote Commands

R&S

FPL1000

627User Manual 1178.3370.02 ─ 09

Remote commands exclusive for performing measurements:

ABORt.......................................................................................................................... 627

INITiate<n>:CONMeas................................................................................................... 627

INITiate<n>:CONTinuous................................................................................................628

INITiate<n>[:IMMediate]..................................................................................................629

[SENSe:]SWEep:COUNt:CURRent?................................................................................629

ABORt

This command aborts the measurement in the current channel setup and resets the

trigger system.

To prevent overlapping execution of the subsequent command before the measure-

ment has been aborted successfully, use the *OPC? or *WAI command after ABOR and

before the next command.

For details see Chapter 10.1.6.1, "Preventing Overlapping Execution", on page 558.

Note on blocked remote control programs:

If a sequential command cannot be completed, for example because a triggered sweep

never receives a trigger, the remote control program will never finish and the remote

channel to the R&S FPL1000 is blocked for further commands. In this case, you must

interrupt processing on the remote channel first in order to abort the measurement.

To do so, send a "Device Clear" command from the control instrument to the

R&S FPL1000 on a parallel channel to clear all currently active remote channels.

Depending on the used interface and protocol, send the following commands:

●

Visa: viClear()

Now you can send the ABORt command on the remote channel performing the mea-

surement.

Example:

ABOR;:INIT:IMM

Aborts the current measurement and immediately starts a new

one.

Example:

ABOR;*WAI

INIT:IMM

Aborts the current measurement and starts a new one once

abortion has been completed.

Usage: Event

INITiate<n>:CONMeas

This command restarts a (single) measurement that has been stopped (using ABORt)

or finished in single sweep mode.

The measurement is restarted at the beginning, not where the previous measurement

was stopped.

Suffix:

<n>

irrelevant

Configuring and Performing Measurements