User Manual

Remote Commands
R&S
®
FPL1000
630User Manual 1178.3370.02 ─ 09
11.6.2 Configuring Power Measurements
The following commands work for several power measurements.
CALCulate<n>:MARKer<m>:FUNCtion:POWer<sb>:MODE...............................................630
CALCulate<n>:MARKer<m>:FUNCtion:POWer<sb>:RESult?.............................................630
CALCulate<n>:MARKer<m>:FUNCtion:POWer<sb>:SELect.............................................. 632
CALCulate<n>:MARKer<m>:FUNCtion:POWer<sb>[:STATe]..............................................632
[SENSe:]POWer:ACHannel:PRESet................................................................................ 633
[SENSe:]POWer:ACHannel:PRESet:RLEVel.....................................................................633
[SENSe:]POWer:TRACe.................................................................................................633
CALCulate<n>:MARKer<m>:FUNCtion:POWer<sb>:MODE <Mode>
This command selects the trace display mode for power measurements.
Suffix:
<n>
.
Window
<m> Marker
<sb> irrelevant
Parameters:
<Mode> WRITe | MAXHold
WRITe
The power is calculated from the current trace.
MAXHold
The power is calculated from the current trace and compared
with the previous power value using a maximum algorithm.
Manual operation: See "Power Mode" on page 137
CALCulate<n>:MARKer<m>:FUNCtion:POWer<sb>:RESult? <Measurement>
This command queries the results of power measurements.
To get a valid result, you have to perform a complete measurement with synchroniza-
tion to the end of the measurement before reading out the result. This is only possible
for single sweep mode.
See also INITiate<n>:CONTinuous on page 628.
Suffix:
<n>
.
irrelevant
<m> irrelevant
Configuring and Performing Measurements