User Manual

Remote Commands
R&S
®
FPL1000
635User Manual 1178.3370.02 ─ 09
Example:
CONF:CME:REF MAN
CONF:CME:REF:VAL -30
Manual operation: See "Reference" on page 125
CONFigure:CMEasurement:REFerence[:MODE] <Mode>
Determines how the reference value for the compression point measurement is
defined.
Parameters:
<Mode> AUTO | MANual
AUTO
The reference value is determined automatically.
MANual
The reference value is defined using CONFigure:
CMEasurement:REFerence:VALue on page 634.
*RST: AUTO
Example:
CONF:CME:REF MAN
CONF:CME:REF:VAL -30
Manual operation: See "Reference" on page 125
CONFigure:CMEasurement:RESult:CVALue <UserCompression>
Defines the compression value for the n dB compression point (see CONFigure:
CMEasurement:RESult:PNDB[:STAT] on page 636).
To query the results of the n dB compression point measurement, use FETCh:
CMEasurement:PNDB[:RESult]? on page 637.
Parameters:
<UserCompression> Distance from the linear trace to the reference trace
Default unit: DB
Example: Enable calculation:
CONF:CME:REF:PNDB ON
Define compression value:
CONF:CME:RES:CVAL 5
Query results:
FETC:CME:PNDB?
Manual operation: See "Compression Points" on page 125
CONFigure:CMEasurement:RESult:P1DB[:STAT] <State>
Enables or disables the calculation of the 1 dB compression point.
Configuring and Performing Measurements