User Manual

Remote Commands
R&S
®
FPL1000
636User Manual 1178.3370.02 ─ 09
To query the results of the 1 dB compression point measurement, use FETCh:
CMEasurement:P1DB[:RESult]? on page 637.
Parameters:
<State> ON | OFF | 0 | 1
OFF | 0
Switches the function off
ON | 1
Switches the function on
*RST: 1
Example: Enable calculation:
CONF:CME:REF:P1DB ON
Query results:
FETC:CME:P1DB?
Manual operation: See "Compression Points" on page 125
CONFigure:CMEasurement:RESult:P3DB[:STAT]
<State>
Enables or disables the calculation of the 3 dB compression point.
To query the results of the 3 dB compression point measurement, use FETCh:
CMEasurement:P3DB[:RESult]? on page 637.
Parameters:
<State> ON | OFF | 0 | 1
OFF | 0
Switches the function off
ON | 1
Switches the function on
*RST: 1
Example: Enable calculation:
CONF:CME:REF:P3DB ON
Query results:
FETC:CME:P3DB?
Manual operation: See "Compression Points" on page 125
CONFigure:CMEasurement:RESult:PNDB[:STAT] <State>
Enables or disables the calculation of the n dB compression point.
To define the compression value, use CONFigure:CMEasurement:RESult:CVALue
on page 635.
To query the results of the n dB compression point measurement, use FETCh:
CMEasurement:PNDB[:RESult]? on page 637.
Parameters:
<State> ON | OFF | 0 | 1
Configuring and Performing Measurements