User Manual

Remote Commands
R&S
®
FPL1000
641User Manual 1178.3370.02 ─ 09
[SENSe:]POWer:ACHannel:SPACing[:ACHannel]............................................................. 642
[SENSe:]POWer:ACHannel:SPACing:ALTernate<ch>........................................................ 643
[SENSe:]POWer:ACHannel:SPACing:CHANnel<ch>......................................................... 643
[SENSe:]POWer:ACHannel:TXCHannel:COUNt................................................................643
[SENSe:]POWer:ACHannel:ACPairs <ChannelPairs>
This command defines the number of pairs of adjacent and alternate channels.
Parameters:
<ChannelPairs> Range: 0 to 12
*RST: 1
Manual operation: See "Number of channels: Tx, Adj" on page 136
[SENSe:]POWer:ACHannel:BWIDth:ACHannel
<Bandwidth>
[SENSe:]POWer:ACHannel:BANDwidth:ACHannel <Bandwidth>
This command defines the channel bandwidth of the adjacent channels.
Parameters:
<Bandwidth> Range: 100 Hz to 1000 MHz
*RST: 14 kHz
Default unit: Hz
Manual operation: See "Channel Bandwidth" on page 139
[SENSe:]POWer:ACHannel:BWIDth:ALTernate<ch> <Bandwidth>
[SENSe:]POWer:ACHannel:BANDwidth:ALTernate<ch> <Bandwidth>
This command defines the channel bandwidth of the alternate channels.
If you set the channel bandwidth for the first alternate channel, the R&S FPL1000 sets
the bandwidth of the other alternate channels to the same value, but not the other way
round. The command works hierarchically: to set a bandwidth of the 3rd and 4th chan-
nel, you have to set the bandwidth of the 3rd channel first.
Suffix:
<ch>
.
1..n
Alternate channel number
Parameters:
<Bandwidth> Range: 100 Hz to 1000 MHz
*RST: 14 kHz
Default unit: Hz
Manual operation: See "Channel Bandwidth" on page 139
[SENSe:]POWer:ACHannel:BWIDth[:CHANnel<ch>] <Bandwidth>
[SENSe:]POWer:ACHannel:BANDwidth[:CHANnel<ch>] <Bandwidth>
This command defines the channel bandwidth of the transmission channels.
Configuring and Performing Measurements