User Manual

Remote Commands
R&S
®
FPL1000
647User Manual 1178.3370.02 ─ 09
Parameters:
<ChannelNumber> Range: 1 to 18
*RST: 1
Manual operation: See "Reference Channel" on page 136
11.6.4.5 Checking Limits
The following commands configure and query limit checks for channel power and
ACLR measurements.
The results of the power limit checks are also indicated in the STAT:QUES:ACPL sta-
tus registry (see "STATus:QUEStionable:ACPLimit Register" on page 567).
CALCulate<n>:LIMit<li>:ACPower:ACHannel:ABSolute..................................................... 647
CALCulate<n>:LIMit<li>:ACPower:ACHannel:ABSolute:STATe........................................... 648
CALCulate<n>:LIMit<li>:ACPower:ACHannel[:RELative]....................................................648
CALCulate<n>:LIMit<li>:ACPower:ACHannel:RESult?.......................................................648
CALCulate<n>:LIMit<li>:ACPower:ACHannel[:RELative]:STATe..........................................649
CALCulate<n>:LIMit<li>:ACPower:ALTernate<ch>:ABSolute.............................................. 649
CALCulate<n>:LIMit<li>:ACPower:ALTernate<ch>:ABSolute:STATe.................................... 650
CALCulate<n>:LIMit<li>:ACPower:ALTernate<ch>[:RELative].............................................650
CALCulate<n>:LIMit<li>:ACPower:ALTernate<ch>:RESult?................................................651
CALCulate<n>:LIMit<li>:ACPower:ALTernate<ch>[:RELative]:STATe...................................652
CALCulate<n>:LIMit<li>:ACPower[:STATe]....................................................................... 652
CALCulate<n>:LIMit<li>:ACPower:ACHannel:ABSolute <LowerLimit>[,
<UpperLimit>]
This command defines the absolute limit of the adjacent channels.
If you have defined an absolute limit as well as a relative limit, the R&S FPL1000 uses
the lower value for the limit check.
Suffix:
<n>
.
irrelevant
<li> irrelevant
Parameters:
<LowerLimit> The limit of the lower adjacent channel.
Range: -200 dBm to 200 dBm
*RST: -200 dBm
Default unit: dBm
<UpperLimit> The limit of the upper adjacent channel.
Range: -200 dBm to 200 dBm
*RST: -200 dBm
Default unit: dBm
Manual operation: See "Limit Check" on page 140
Configuring and Performing Measurements