User Manual

Remote Commands
R&S
®
FPL1000
678User Manual 1178.3370.02 ─ 09
Return values:
<RefRange> Number of the current reference range.
Range: 1 to 30
Usage: Query only
[SENSe:]ESPectrum<sb>:RTYPe <Type>
This command defines the type of the power reference.
Suffix:
<sb>
.
1 to 3
Sub block in a Multi-SEM measurement
Parameters:
<Type> PEAK | CPOWer
PEAK
Measures the highest peak within the reference range.
CPOWer
Measures the channel power within the reference range (integral
bandwidth method).
*RST: CPOWer
Manual operation: See "Power Reference Type" on page 181
11.6.7.6 Configuring the Power Classes
The following commands define the power classes for SEM measurements.
CALCulate<n>:LIMit<li>:ESPectrum<sb>:LIMits................................................................678
CALCulate<n>:LIMit<li>:ESPectrum<sb>:MODE...............................................................679
CALCulate<n>:LIMit<li>:ESPectrum<sb>:VALue...............................................................680
CALCulate<n>:LIMit<li>:ESPectrum<sb>:PCLass<pc>:COUNt...........................................680
CALCulate<n>:LIMit<li>:ESPectrum<sb>:PCLass<pc>[:EXCLusive]................................... 681
CALCulate<n>:LIMit<li>:ESPectrum<sb>:PCLass<pc>:LIMit[:STATe].................................. 681
CALCulate<n>:LIMit<li>:ESPectrum<sb>:PCLass<pc>:MAXimum...................................... 682
CALCulate<n>:LIMit<li>:ESPectrum<sb>:PCLass<pc>:MINimum....................................... 683
CALCulate<n>:LIMit<li>:ESPectrum<sb>:LIMits <Max1>,<Max2>,<Max3>
This command sets or queries up to 4 power classes in one step. You can only define
values for the number of power classes defined by CALCulate<n>:LIMit<li>:
ESPectrum<sb>:PCLass<pc>:COUNt on page 680.
Suffix:
<n>
.
irrelevant
<li> irrelevant
<sb> 1 to 3
Configuring and Performing Measurements