User Manual

ManualsBrandsRohde & Schwarz ManualsSignal Generators & Spectrum AnalysersSpectrum Analyser Portable, 3GHz, 50Ohm

681

682

683

684

685

686

687

688

689

690

Remote Commands

R&S

FPL1000

683User Manual 1178.3370.02 ─ 09

CALCulate<n>:LIMit<li>:ESPectrum<sb>:PCLass<pc>:MINimum <Level>

This command defines the lower limit of a particular power class.

Note:

●

The first power class always has a lower limit of -200 dBm.

●

The lower limit of a power class must always be the same as the upper limit of the

previous power class.

●

The power class must already exist (see CALCulate<n>:LIMit<li>:

ESPectrum<sb>:PCLass<pc>:COUNt on page 680).

Suffix:

<n>

irrelevant

<li> irrelevant

<sb> 1 to 3

<pc> 1..n

power class

Parameters:

<Level> Range: -200 dBm to 199.9 dBm

Default unit: dBm

Example:

CALC:LIM:ESP:PCL2:MIN -40 dBm

Sets the minimum power value of the second power class to -40

dBm.

Manual operation: See "PMin/ PMax" on page 183

11.6.7.7 Configuring the List Evaluation

The following commands configure the list evaluation.

Useful commands for SEM measurements described elsewhere

●

MMEMory:STORe<n>:LIST on page 942

Remote commands exclusive to SEM measurements

CALCulate<n>:ESPectrum:PSEarch:AUTO...................................................................... 683

CALCulate<n>:ESPectrum:PEAKsearch:AUTO.................................................................683

CALCulate<n>:ESPectrum:PSEarch[:IMMediate].............................................................. 684

CALCulate<n>:ESPectrum:PEAKsearch[:IMMediate].........................................................684

CALCulate<n>:ESPectrum:PSEarch:MARGin...................................................................684

CALCulate<n>:ESPectrum:PEAKsearch:MARGin............................................................. 684

CALCulate<n>:ESPectrum:PSEarch:PSHow.................................................................... 684

CALCulate<n>:ESPectrum:PEAKsearch:PSHow...............................................................684

CALCulate<n>:ESPectrum:PSEarch:AUTO <State>

CALCulate<n>:ESPectrum:PEAKsearch:AUTO <State>

This command turns the list evaluation on and off.

Configuring and Performing Measurements