User Manual

Remote Commands
R&S
®
FPL1000
693User Manual 1178.3370.02 ─ 09
The available bandwidths of the filters are specified in the data
sheet.
Example:
LIST:RANG2:FILT:TYPE NORM
Manual operation: See "Filter Type" on page 205
[SENSe:]LIST:RANGe<ri>:INPut:ATTenuation <Attenuation>
This command defines the input attenuation for a spurious emission measurement
range.
Suffix:
<ri>
.
1..n
Selects the measurement range.
Parameters:
<Attenuation> Numeric value.
Refer to the data sheet for the attenuation range.
*RST: 10 dB
Default unit: dB
Example:
LIST:RANG2:INP:ATT 5
Manual operation: See "RF Attenuation" on page 206
[SENSe:]LIST:RANGe<ri>:INPut:ATTenuation:AUTO <State>
This command turns automatic selection of the input attenuation for a spurious emis-
sion measurement range on and off.
Suffix:
<ri>
.
1..n
Selects the measurement range.
Parameters:
<State> ON | OFF | 0 | 1
*RST: 1
Example:
LIST:RANG2:INP:ATT:AUTO ON
Manual operation: See "RF Attenuation Mode" on page 206
[SENSe:]LIST:RANGe<ri>:INPut:GAIN:STATe <State>
This command turns the preamplifier for a spurious emission measurement range on
and off.
Suffix:
<ri>
.
1..n
Selects the measurement range.
Parameters:
<State> ON | OFF | 1 | 0
*RST: 0
Configuring and Performing Measurements