Manualshelf

User Manual

ManualsBrandsRohde & Schwarz ManualsSignal Generators & Spectrum AnalysersSpectrum Analyser Portable, 3GHz, 50Ohm
701702703704705706707708709710
Remote Commands
R&S
®
FPL1000
705User Manual 1178.3370.02 ─ 09
OFF | 0
Switches the function off
ON | 1
Switches the function on
Example:
SWE:EGAT:TRAC1:STAT1 ON
Activates gate range 1 for trace 1.
Manual operation: See "Gated Trigger" on page 218
See "Range <x> Use" on page 219
[SENSe:]SWEep:EGATe:TRACe<t>:STOP<gr> <Time>
This command defines the stop time for a gate range.
Suffix:
<t>
.
Trace
<gr> 1..n
gate range
Parameters:
<Time> The value range depends on the gate period you have set for
the selected trace with [SENSe:]SWEep:EGATe:TRACe<t>:
PERiod. The following rules apply:
• the stop time may not be higher than the length of the gate
• the stop time may not be lower than the start time
The reset values depend on the gate range.
• for gate range 1, the stop time is 1 ms
• for gate range 3, the stop time is 3 ms
• for gate range 5, the stop time is 5 ms
Default unit: s
Example:
SWE:EGAT:TRAC1:STOP1 5ms
Sets the stopping point for range 1 on trace 1 at 5 ms.
Manual operation: See "Range <x> Start/Stop" on page 219
11.6.9.4 Scaling the Diagram
The following commands set up the diagram for statistical measurements.
CALCulate<n>:STATistics:PRESet...................................................................................705
CALCulate<n>:STATistics:SCALe:AUTO ONCE................................................................706
CALCulate<n>:STATistics:SCALe:X:RANGe.....................................................................706
CALCulate<n>:STATistics:SCALe:X:RLEVel..................................................................... 707
CALCulate<n>:STATistics:SCALe:Y:LOWer......................................................................707
CALCulate<n>:STATistics:SCALe:Y:UNIT.........................................................................707
CALCulate<n>:STATistics:SCALe:Y:UPPer.......................................................................708
CALCulate<n>:STATistics:PRESet
This command resets the scale of the diagram (x- and y-axis).
Configuring and Performing Measurements