User Manual

Remote Commands
R&S
®
FPL1000
729User Manual 1178.3370.02 ─ 09
//-----------Configuring the measurement ------------
*RST
//Reset the instrument
FREQ:CENT 100MHz
//Set center frequency
FREQ:SPAN 10KHz
// Set span
CALC:MARK:FUNC:MDEP ON
//Activate AM modulation depth measurement.
//--------------Performing the Measurement-----
INIT:CONT OFF
//Selects single sweep mode.
INIT:IMM
// Perform a single measurement
CALC:MARK:FUNC:MDEP:SEAR ONCE
//Initiates a search for signals in the current trace.
//---------------Retrieving Results-------------
CALC:MARK:FUNC:MDEP:RES?
//Queries the measurement results.
//If the results are not accurate, change the position of the
//the temporary markers manually.
//----Changing the position of the temp markers-----
CALC:MARK:X 100MHZ
//Positions the reference marker on 100 MHz.
CALC:DELT2:X 5KHZ
//Positions delta marker 2 and 3 at a distance of 5 kHz to the reference marker.
CALC:DELT3:X 1KHZ
//Corrects the position of delta marker 3 by 1 kHz.
CALC:MARK:FUNC:MDEP:RES?
//Queries the measurement results for the repositioned markers.
11.6.14 Remote Commands for EMI Measurements
The following commands are required to perform EMI measurements in a remote envi-
ronment. This measurement requires the R&S FPL1-K54 option.
The following tasks specific to the EMI application are described here:
● Activating EMI Measurement................................................................................ 730
● Configuring EMI Markers...................................................................................... 730
● Configuring the EMI Final Test..............................................................................731
● Configuring EMI Limit Lines.................................................................................. 732
● Controlling LISN....................................................................................................732
Configuring and Performing Measurements