User Manual

ManualsBrandsRohde & Schwarz ManualsSignal Generators & Spectrum AnalysersSpectrum Analyser Portable, 3GHz, 50Ohm

721

722

723

724

725

726

727

728

729

730

Remote Commands

R&S

FPL1000

730User Manual 1178.3370.02 ─ 09

● Retrieving EMI Results..........................................................................................734

● Evaluating the Results.......................................................................................... 736

● Programming Example: EMI Measurement.......................................................... 736

11.6.14.1 Activating EMI Measurement

EMI measurement must be activated explicitely.

CALCulate<n>:DELTamarker<m>:FUNCtion:FMEasurement[:STATe]..................................730

CALCulate<n>:MARKer<m>:FUNCtion:FMEasurement[:STATe]......................................... 730

CALCulate<n>:DELTamarker<m>:FUNCtion:FMEasurement[:STATe] <State>

CALCulate<n>:MARKer<m>:FUNCtion:FMEasurement[:STATe] <State>

This command turns the EMI measurement marker functionality on and off.

Suffix:

<n>

irrelevant

<m> irrelevant

Parameters:

<State> ON | OFF | 1 | 0

11.6.14.2 Configuring EMI Markers

The commands required to configure EMI markers are described here.

Useful commands for configuring EMI markers described elsewhere:

●

CALCulate<n>:MARKer<m>[:STATe] on page 844

CALCulate<n>:DELTamarker<m>[:STATe] on page 842

●

CALCulate<n>:MARKer<m>[:STATe] on page 844

CALCulate<n>:DELTamarker<m>[:STATe] on page 842

●

CALCulate<n>:DELTamarker<m>:MREFerence on page 842

●

CALCulate<n>:MARKer<ms>:LINK:TO:MARKer<md> on page 844

CALCulate<n>:DELTamarker<ms>:LINK:TO:MARKer<md> on page 841

CALCulate<n>:DELTamarker<m>:LINK on page 840

●

CALCulate<n>:MARKer<m>:TRACe on page 844

Remote commands exclusive to configuring EMI markers

CALCulate<n>:DELTamarker<m>:FUNCtion:FMEasurement:DETector................................730

CALCulate<n>:MARKer<m>:FUNCtion:FMEasurement:DETector....................................... 730

CALCulate<n>:DELTamarker<m>:FUNCtion:FMEasurement:DETector <Detector>

CALCulate<n>:MARKer<m>:FUNCtion:FMEasurement:DETector <Detector>

This command selects the detector for a specific marker during the final measurement.

If the marker is not yet active, the command also turns the marker on.

Configuring and Performing Measurements