User Manual

ManualsBrandsRohde & Schwarz ManualsSignal Generators & Spectrum AnalysersSpectrum Analyser Portable, 3GHz, 50Ohm

761

762

763

764

765

766

767

768

769

770

Remote Commands

R&S

FPL1000

769User Manual 1178.3370.02 ─ 09

11.8.2.1 Configuring the Bandwidth and Filter

[SENSe:]BWIDth[:RESolution].........................................................................................769

[SENSe:]BANDwidth[:RESolution]................................................................................... 769

[SENSe:]BWIDth[:RESolution]:AUTO...............................................................................769

[SENSe:]BANDwidth[:RESolution]:AUTO..........................................................................769

[SENSe:]BWIDth[:RESolution]:RATio............................................................................... 770

[SENSe:]BANDwidth[:RESolution]:RATio..........................................................................770

[SENSe:]BWIDth[:RESolution]:TYPE................................................................................770

[SENSe:]BANDwidth[:RESolution]:TYPE.......................................................................... 770

[SENSe:]BWIDth:VIDeo..................................................................................................771

[SENSe:]BANDwidth:VIDeo............................................................................................ 771

[SENSe:]BWIDth:VIDeo:AUTO........................................................................................771

[SENSe:]BANDwidth:VIDeo:AUTO...................................................................................771

[SENSe:]BWIDth:VIDeo:RATio........................................................................................ 771

[SENSe:]BANDwidth:VIDeo:RATio...................................................................................771

[SENSe:]BWIDth:VIDeo:TYPE.........................................................................................772

[SENSe:]BANDwidth:VIDeo:TYPE................................................................................... 772

[SENSe:]BWIDth[:RESolution] <Bandwidth>

[SENSe:]BANDwidth[:RESolution] <Bandwidth>

This command defines the resolution bandwidth and decouples the resolution band-

width from the span.

For statistics measurements, this command defines the demodulation bandwidth.

Parameters:

<Bandwidth> refer to data sheet

*RST: RBW: AUTO is set to ON; DBW: 3MHz

Default unit: Hz

Example:

BAND 1 MHz

Sets the resolution bandwidth to 1 MHz

Manual operation: See "Analysis Bandwidth" on page 217

See "RBW" on page 266

See "Res BW CISPR" on page 268

See "Res BW MIL" on page 268

See "RBW" on page 336

[SENSe:]BWIDth[:RESolution]:AUTO <State>

[SENSe:]BANDwidth[:RESolution]:AUTO <State>

This command couples and decouples the resolution bandwidth to the span.

Parameters:

<State> ON | OFF | 0 | 1

*RST: 1

Example:

BAND:AUTO OFF

Switches off the coupling of the resolution bandwidth to the

span.

Setting Basic Spectrum RF Measurement Parameters