User Manual

Remote Commands
R&S
®
FPL1000
776User Manual 1178.3370.02 ─ 09
11.8.3 Configuring the Vertical Axis (Amplitude, Scaling)
The following commands are required to configure the amplitude and vertical axis set-
tings in a remote environment.
● Amplitude Settings................................................................................................ 776
● Configuring the Attenuation...................................................................................778
● Configuring a Preamplifier.....................................................................................779
● Scaling the Y-Axis................................................................................................. 779
11.8.3.1 Amplitude Settings
The tasks for manual configuration are described in Chapter 7.5.2, "Amplitude Set-
tings", on page 310.
Useful commands for amplitude configuration described elsewhere:
●
[SENSe:]ADJust:LEVel on page 766
Remote commands exclusive to amplitude configuration:
CALCulate<n>:MARKer<m>:FUNCtion:REFerence...........................................................776
CALCulate<n>:UNIT:POWer........................................................................................... 776
UNIT<n>:POWer............................................................................................................776
DISPlay[:WINDow<n>]:TRACe<t>:Y[:SCALe]:RLEVel........................................................777
DISPlay[:WINDow<n>]:TRACe<t>:Y[:SCALe]:RLEVel:OFFSet........................................... 777
CALCulate<n>:MARKer<m>:FUNCtion:REFerence
This command matches the reference level to the power level of a marker.
If you use the command in combination with a delta marker, that delta marker is turned
into a normal marker.
Suffix:
<n>
.
Window
<m> Marker
Example:
CALC:MARK2:FUNC:REF
Sets the reference level to the level of marker 2.
Manual operation: See "Reference Level = Marker Level" on page 362
CALCulate<n>:UNIT:POWer <Unit>
UNIT<n>:POWer <Unit>
This command selects the unit of the y-axis.
The unit applies to all power-based measurement windows with absolute values.
Suffix:
<n>
.
irrelevant
Setting Basic Spectrum RF Measurement Parameters