User Manual

ManualsBrandsRohde & Schwarz ManualsSignal Generators & Spectrum AnalysersSpectrum Analyser Portable, 3GHz, 50Ohm

791

792

793

794

795

796

797

798

799

800

Remote Commands

R&S

FPL1000

793User Manual 1178.3370.02 ─ 09

Example:

SYST:COMM:RDEV:PMET2:DEF '','NRP-Z81','',

'123456'

Assigns the power sensor with the serial number '123456' to the

configuration "Power Sensor 2".

SYST:COMM:RDEV:PMET2:DEF?

Queries the sensor assigned to "Power Sensor 2".

Result:

'','NRP-Z81','USB','123456'

The NRP-Z81 power sensor with the serial number '123456' is

assigned to the "Power Sensor 2".

Manual operation: See "Select" on page 279

Configuring Power Sensor Measurements

CALibration:PMETer:ZERO:AUTO ONCE................................................................... 793

CALCulate<n>:PMETer:RELative[:MAGNitude]............................................................794

CALCulate<n>:PMETer:RELative[:MAGNitude]:AUTO ONCE....................................... 794

CALCulate<n>:PMETer:RELative:STATe.....................................................................794

FETCh:PMETer?...................................................................................................... 795

READ:PMETer?....................................................................................................... 795

[SENSe:]PMETer:DCYCle[:STATe]............................................................................. 795

[SENSe:]PMETer:DCYCle:VALue...............................................................................795

[SENSe:]PMETer:FREQuency................................................................................... 796

[SENSe:]PMETer:FREQuency:LINK........................................................................... 796

[SENSe:]PMETer:MTIMe...........................................................................................796

[SENSe:]PMETer:MTIMe:AVERage:COUNt.................................................................797

[SENSe:]PMETer:MTIMe:AVERage[:STATe]................................................................ 797

[SENSe:]PMETer:ROFFset[:STATe]............................................................................798

[SENSe:]PMETer:SOFFset........................................................................................798

[SENSe:]PMETer[:STATe]..........................................................................................798

[SENSe:]PMETer:UPDate[:STATe]..............................................................................799

UNIT<n>:PMETer:POWer..........................................................................................799

UNIT<n>:PMETer:POWer:RATio................................................................................ 799

CALibration:PMETer:ZERO:AUTO ONCE

This command zeroes the power sensor.

Note that you have to disconnect the signals from the power sensor input before you

start to zero the power sensor. Otherwise, results are invalid.

Suffix:

Power sensor index

Example:

CAL:PMET2:ZERO:AUTO ONCE;*WAI

Starts zeroing the power sensor 2 and delays the execution of

further commands until zeroing is concluded.

Usage: Event

Manual operation: See "Zeroing Power Sensor" on page 279

Setting Basic Spectrum RF Measurement Parameters