User Manual

Remote Commands
R&S
®
FPL1000
800User Manual 1178.3370.02 ─ 09
11.8.5.3 Internal Generator Commands
The following commands are required to configure an internal generator. They are only
available if the Tracking Generator option R&S FPL1-B9 is installed.
For details see Chapter 7.3.3.1, "Basics on the Internal Generator", on page 283.
Useful commands for internal generators described elsewhere:
●
Chapter 11.6.3.1, "Configuring the Compression Point Measurement", on page 634
● Independant CW Source Commands................................................................... 800
● Tracking Generator Commands............................................................................801
● Power Sweep Commands.....................................................................................805
● Programming Example for a Tracking Generator................................................. 807
Independant CW Source Commands
The following commands are required to configure an internal generator as an inde-
pendant CW source.
OUTPut<up>[:STATe]..................................................................................................... 800
SOURce<si>:INTernal:FREQuency..................................................................................800
SOURce<si>:POWer[:LEVel][:IMMediate][:AMPLitude]...................................................... 801
SOURce<si>:POWer[:LEVel][:IMMediate]:OFFSet.............................................................801
OUTPut<up>[:STATe] <State>
Enables or disables the internal generator. The generator signal is output at the GEN
Output 50 Ω connector on the front panel.
Suffix:
<up>
.
Parameters:
<State> ON | OFF | 0 | 1
OFF | 0
Switches the function off
ON | 1
Switches the function on
*RST: 0
Example:
OUTP ON
Manual operation: See "State" on page 291
SOURce<si>:INTernal:FREQuency <Frequency>
Defines the frequency of the internal generator signal.
Suffix:
<si>
.
irrelevant
Setting Basic Spectrum RF Measurement Parameters