User Manual

Remote Commands
R&S
®
FPL1000
802User Manual 1178.3370.02 ─ 09
●
SOURce<si>:POWer[:LEVel][:IMMediate][:AMPLitude] on page 801
●
SOURce<si>:POWer[:LEVel][:IMMediate]:OFFSet on page 801
Remote commands exclusive to tracking generators:
SOURce<si>:FREQuency:COUPling[:STATe]....................................................................802
SOURce<si>:INTernal:FREQuency:OFFSet......................................................................802
[SENSe:]CORRection[:STATe].........................................................................................802
[SENSe:]CORRection:COLLect[:ACQuire]........................................................................803
[SENSe:]CORRection:METHod....................................................................................... 804
[SENSe:]CORRection:RECall..........................................................................................804
[SENSe:]CORRection:TRANsducer:GENerate..................................................................804
DISPlay[:WINDow<n>][:SUBWindow<w>]:TRACe<t>:Y[:SCALe]:RVALue............................805
SOURce<si>:FREQuency:COUPling[:STATe] <State>
Enables or disables the usage of the internal generator as a tracking generator. The
tracking generator is only available for frequency sweeps in the Spectrum application.
Suffix:
<si>
.
1..n
Parameters:
<State> ON | OFF | 0 | 1
OFF | 0
Switches the tracking generator off
ON | 1
Switches the tracking generator on
*RST: 0
Example:
SOUR:FREQ:COUP:STAT ON
Manual operation: See "Usage" on page 291
SOURce<si>:INTernal:FREQuency:OFFSet <FreqOffset>
Defines an offset of the tracking generator signal to the analyzer frequency.
Suffix:
<si>
.
1..n
Parameters:
<FreqOffset> Default unit: HZ
Example:
SOUR:INT:FREQ:OFFS 10kHz
Manual operation: See "Frequency Offset" on page 293
[SENSe:]CORRection[:STATe] <State>
This command turns correction of measurement results (normalization) on and off.
Setting Basic Spectrum RF Measurement Parameters