User Manual

Remote Commands
R&S
®
FPL1000
811User Manual 1178.3370.02 ─ 09
Manual operation: See "Data Output" on page 300
See "Loudspeaker" on page 378
SYSTem:SPEaker:MUTE
Temporarily disables the audio output via the built-in loudspeakers.
Example:
SYST:SPE:MUTE
Manual operation: See "Data Output" on page 300
SYSTem:SPEaker:VOLume <Volume>
This command defines the volume of the built-in loudspeaker for demodulated signals.
This setting is maintained for all applications.
The command is available in the time domain in Spectrum mode and in Analog Modu-
lation Analysis mode.
Note that you must switch the loudspeaker on first, using the SYSTem:SPEaker[:
STATe] command.
Parameters:
<Volume> Percentage of the maximum possible volume.
Range: 0 to 1
*RST: 0.5
Example:
SYST:SPE:VOL 0
Switches the loudspeaker to mute.
Manual operation: See "Data Output" on page 300
See "Audio Output Volume" on page 378
11.8.6 Zooming into the Display
11.8.6.1 Using the Single Zoom
DISPlay[:WINDow<n>][:SUBWindow<w>]:ZOOM:AREA.................................................... 811
DISPlay[:WINDow<n>][:SUBWindow<w>]:ZOOM[:STATe]..................................................813
DISPlay[:WINDow<n>][:SUBWindow<w>]:ZOOM:AREA <x1>,<y1>,<x2>,<y2>
This command defines the zoom area.
To define a zoom area, you first have to turn the zoom on.
Setting Basic Spectrum RF Measurement Parameters