User Manual

Remote Commands
R&S
®
FPL1000
832User Manual 1178.3370.02 ─ 09
REAL
Floating-point numbers (according to IEEE 754) in the "definite
length block format".
In the Spectrum application, the format setting REAL is used for
the binary transmission of trace data.
<BitLength> 16 | 32 | 64
Length in bits for floating-point results
32
32-bit floating-point numbers
For I/Q data, 8 bytes per sample are returned for this format set-
ting.
Example:
FORM REAL,32
TRACe<n>[:DATA] <Trace>,<Data>
TRACe<n>[:DATA]? <ResultType>
This command queries current trace data and measurement results.
The data format depends on FORMat[:DATA] on page 831.
Suffix:
<n>
.
Window
Parameters:
<Trace> Selects the trace to write the data to.
TRACE1 | TRACE2 | TRACE3 | TRACE4 | TRACE5 | TRACE6
<Data> Contains the data to transfer.
Query parameters:
<ResultType> Selects the type of result to be returned.
TRACE1 | ... | TRACE6
Returns the trace data for the corresponding trace.
For details see Table 11-6.
LIST
Returns the results of the peak list evaluation for Spurious Emis-
sion and Spectrum Emission Mask measurements.
For SEM measurements, one peak per range is returned.
For details see Table 11-7.
SPURious
Returns the peak list of Spurious Emission measurements.
SPECtrogram | SGRam
Returns the results of the spectrogram result display.
For details see Table 11-8.
Return values:
<TraceData> For more information see tables below.
Example:
TRAC TRACE1,+A$
Transfers trace data ('+A$') to trace 1.
Setting Basic Spectrum RF Measurement Parameters