User Manual

Remote Commands
R&S
®
FPL1000
845User Manual 1178.3370.02 ─ 09
If necessary, the command activates the marker first.
Suffix:
<n>
.
Window
<m> Marker
Parameters:
<Trace> 1 to 6
Trace number the marker is assigned to.
Example: //Assign marker to trace 1
CALC:MARK3:TRAC 2
Manual operation: See "Assigning the Marker to a Trace" on page 263
CALCulate<n>:MARKer<m>:X
<Position>
This command moves a marker to a specific coordinate on the x-axis.
If necessary, the command activates the marker.
If the marker has been used as a delta marker, the command turns it into a normal
marker.
Suffix:
<n>
.
Window
<m> Marker
Parameters:
<Position> Numeric value that defines the marker position on the x-axis.
The unit depends on the result display.
Range: The range depends on the current x-axis range.
Default unit: Hz
Example:
CALC:MARK2:X 1.7MHz
Positions marker 2 to frequency 1.7 MHz.
Manual operation: See "Marker Table" on page 117
See "Marker Peak List" on page 118
See "Marker 1/Marker 2/Marker 3/Marker 4" on page 244
See "Marker 1/Marker 2/Marker 3" on page 248
See "Marker Position X-value" on page 262
11.8.8.2 General Marker Settings
The following commands control general marker functionality.
Remote commands exclusive to general marker functionality
DISPlay[:WINDow<n>]:MTABle....................................................................................... 846
DISPlay[:WINDow<n>]:MINFo[:STATe].............................................................................846
CALCulate<n>:MARKer<m>:X:SSIZe.............................................................................. 846
Setting Basic Spectrum RF Measurement Parameters