User Manual

Remote Commands
R&S
®
FPL1000
902User Manual 1178.3370.02 ─ 09
CALCulate<n>:LIMit<li>:UPPer[:DATA].............................................................................908
CALCulate<n>:LIMit<li>:UPPer:MARGin.......................................................................... 908
CALCulate<n>:LIMit<li>:UPPer:MODE.............................................................................909
CALCulate<n>:LIMit<li>:UPPer:OFFSet........................................................................... 909
CALCulate<n>:LIMit<li>:UPPer:SHIFt.............................................................................. 909
CALCulate<n>:LIMit<li>:UPPer:SPACing..........................................................................910
CALCulate<n>:LIMit<li>:UPPer:STATe............................................................................. 910
CALCulate<n>:LIMit<li>:UPPer:THReshold...................................................................... 910
CALCulate<n>:LIMit<li>:COMMent <Comment>
This command defines a comment for a limit line.
Suffix:
<n>
.
irrelevant
<li> Limit line
Parameters:
<Comment> String containing the description of the limit line.
Manual operation: See "Comment" on page 429
CALCulate<n>:LIMit<li>:CONTrol[:DATA] <LimitLinePoints>
This command defines the horizontal definition points of a limit line.
Suffix:
<n>
.
irrelevant
<li> Limit line
Parameters:
<LimitLinePoints> Variable number of x-axis values.
Note that the number of horizontal values has to be the same as
the number of vertical values set with CALCulate<n>:
LIMit<li>:LOWer[:DATA] or CALCulate<n>:LIMit<li>:
UPPer[:DATA]. If not, the R&S FPL1000 either adds missing
values or ignores surplus values.
The unit is Hz or s.
*RST: -
Default unit: HZ
Manual operation: See "Data Points" on page 430
CALCulate<n>:LIMit<li>:CONTrol:DOMain <SpanSetting>
This command selects the domain of the limit line.
Suffix:
<n>
.
irrelevant
Setting Basic Spectrum RF Measurement Parameters