User Manual

The Spectrum Application (RF Measurements)

R&S

FPL1000

95User Manual 1178.3370.02 ─ 09

Using this overview, you can easily configure an entire channel setup from input over

processing to output and analysis by stepping through the dialog boxes as indicated.

In particular, the "Overview" provides quick access to the following configuration dialog

boxes (listed in the recommended order of processing):

1. "Select Measurement"

See Chapter 7.2, "Measurements and Results", on page 96

2. Input

See Chapter 7.3.1, "Radio Frequency Input", on page 275

3. Amplitude

See Chapter 7.5, "Amplitude and Vertical Axis Configuration", on page 307

4. Frequency

See Chapter 7.4, "Frequency and Span Configuration", on page 301

5. (Optionally:) Trigger/Gate

See Chapter 7.7, "Trigger and Gate Configuration", on page 331

6. Bandwidth

See Chapter 7.6.2, "Bandwidth, Filter and Sweep Settings", on page 321

(For SEM measurements: SEM Setup, see Chapter 7.2.7.5, "SEM Configuration",

on page 173)

(For Spurious measurements: Spurious Setup, see Chapter 7.2.8.4, "Spurious

Emissions Measurement Configuration", on page 203)

7. (Optionally:) Outputs

Requires option R&S FPL1-B5, see Chapter 7.3.4, "Output Settings", on page 299

8. Analysis

See Chapter 7.10, "Trace Configuration", on page 386 and Chapter 7.9, "Marker

Usage", on page 345

9. Display

See Chapter 6.6, "Configuring Result Displays", on page 88

To configure settings

► Select any button to open the corresponding dialog box.

Select a setting in the channel setup bar (at the top of the channel setup tab) to

change a specific setting.

Preset Channel Setup

Select the "Preset Channel" button in the lower left-hand corner of the "Overview" to

restore all measurement settings in the current channel setup to their default values.

Do not confuse the "Preset Channel" button with the [Preset] key, which restores the

entire instrument to its default values and thus closes all channel setups on the

R&S FPL1000 (except for the default channel setup)!

Remote command:

SYSTem:PRESet:CHANnel[:EXEC] on page 931

Configuration Overview