User Manual

Common Instrument Functions
R&S
®
FPL1000
145User Manual 1178.3370.02 ─ 03
NONE .........................................................................................................................145
Calibration Frequency RF .......................................................................................... 145
└ Frequency ....................................................................................................145
NONE
Uses the current RF signal at the input, i.e. no calibration signal (default).
Remote command:
DIAGnostic:SERVice:INPut[:SELect] on page 818
Calibration Frequency RF
Uses the internal calibration signal as the RF input signal.
Remote command:
DIAGnostic:SERVice:INPut[:SELect] on page 818
DIAGnostic:SERVice:INPut:PULSed:CFRequency on page 818
Frequency ← Calibration Frequency RF
Defines the frequency of the internal broadband calibration signal to be used for IF fil-
ter calibration (max. 64 MHz).
6.3.5.4 Service Functions
Access: SETUP > "Service" > "Service Function"
Using service functions
The service functions are not necessary for normal measurement operation. Incorrect
use can affect correct operation and/or data integrity of the R&S FPL1000.
Therefore, only user accounts with administrator rights can use service functions and
many of the functions can only be used after entering a password. These functions are
described in the instrument service manual.
General Instrument Setup