User Manual

Common Instrument Functions
R&S
®
FPL1000
204User Manual 1178.3370.02 ─ 03
Remote command:
SYSTem:ERRor:DISPlay on page 832
SYSTem:ERRor:CLEar:REMote on page 836
6.4.2.3 Compatibility Settings
Access: SETUP > "Network+Remote" > "Compatibility"
The R&S FPL1000 can emulate the GPIB interface of other signal and spectrum ana-
lyzers, e.g. in order to use existing control applications.
Compatibility with former R&S signal and spectrum analyzers
As a rule, the R&S FPL1000 supports most commands from previous R&S signal and
spectrum analyzers such as the FSQ, FSP, FSU, or FSV. However, the default values,
in particular the number of sweep points or particular bandwidths, may vary. Therefore,
the R&S FPL1000 can emulate some other devices, including their default values, in
order to repeat previous measurements or support existing control applications as in
legacy systems.
Language.................................................................................................................... 204
Language
Defines the system language used to control the instrument.
Note: Emulating previous R&S signal and spectrum analyzers. This function is also
used to emulate previous R&S signal and spectrum analyzers.
As a rule, the R&S FPL1000 supports most commands from previous R&S signal and
spectrum analyzers. However, the default values, in particular the number of sweep
points or particular bandwidths, may vary. Therefore, the R&S FPL1000 can emulate
some other devices, including their default values, in order to repeat previous mea-
surements or support existing control applications as in legacy systems.
"SCPI"
(Default) The default R&S FPL1000 commands are used.
"FSV"
The commands and settings for the R&S FSV instrument are used.
"FSL"
The commands and settings for the R&S FSL instrument are used.
Network and Remote Operation