User Manual

Common Instrument Functions
R&S
®
FPL1000
226User Manual 1178.3370.02 ─ 03
The options to configure the R&S FPL1000 screen display are displayed.
10. Under "Remote desktop size", you can set the size of the R&S FPL1000 window
on the desktop of the controller.
11. Under "Colors", do not change the settings.
12. Set the "Display the connection bar when I use the full screen" option:
If activated, a bar showing the network address of the R&S FPL1000 will appear at
the top edge of the screen. You can use this bar to reduce, minimize or close the
window.
If deactivated, the only way you can return to the controller desktop from the
R&S FPL1000 screen in full screen mode is to select "Disconnect" from the "Start"
menu.
How to Start and Close the Remote Desktop
To set up a connection to the R&S FPL1000
1. In the "Remote Desktop Connection" dialog box (see "How to Configure the Con-
troller" on page 224), open the "General" tab.
2. In the "Computer" field, enter the IP address of the R&S FPL1000.
In the "User name" field, enter instrument to log in as an administrator, or Normal
User to log in as a standard user.
In the "Password" field, enter 894129.
3. To save the connection configuration for later use:
a) Select the "Save As" button.
The "Save As" dialog box is displayed.
b) Enter the name for the connection information (*.RDP).
4. To load an existing connection configuration:
a) Select the "Open" button.
The "Open" dialog box is displayed.
b) Select the *.RDP file.
5. Select the "Connect" button.
The connection is set up.
6. If the "Disk drives" option is activated on the "Local Resources" tab, a warning is
displayed indicating that the drives are enabled for access from the R&S FPL1000.
Select "OK" to confirm the warning.
7. After a few moments, the R&S FPL1000 screen is displayed.
If a dark screen appears or a dark square appears in the upper left-hand corner of
the screen, you must restart the R&S FPL1000 in order to see the modified screen
resolution.
Network and Remote Operation