User Manual

The Spectrum Application (RF Measurements)
R&S
®
FPL1000
253User Manual 1178.3370.02 ─ 03
Figure 7-19: Measurement of the signal-to-noise ratio of a GSM burst signal in zero span
7.2.2 Basic Evaluation Methods
Measurement results can be displayed and evaluated using various different methods,
also at the same time. Depending on the currently selected measurement, in particular
when using optional firmware applications, not all evaluation methods are available.
The evaluation methods described here are available for most measurements in the
Spectrum application.
Diagram ......................................................................................................................253
Marker Table ..............................................................................................................254
Marker Peak List ........................................................................................................ 254
Result Summary .........................................................................................................255
Spectrogram ...............................................................................................................255
Diagram
Displays a basic level vs. frequency or level vs. time diagram of the measured data to
evaluate the results graphically. This is the default evaluation method. Which data is
displayed in the diagram depends on the "Trace" settings. Scaling for the y-axis can be
configured.
Measurements and Results