User Manual

The Spectrum Application (RF Measurements)
R&S
®
FPL1000
262User Manual 1178.3370.02 ─ 03
than the signal bandwidth. Thus, the signal path can be overloaded although the trace
is still significantly below the reference level.
Selecting a predefined standard or automatically adjusting settings does not affect the
reference level. The reference level can be set automatically using the "Auto Level"
function in the AUTO SET menu, or manually in the "Amplitude" menu.
7.2.3.4 Channel Power Configuration
Access: "Overview" > "Select Measurement" > "Channel Power ACLR" > "CP / ACLR
Config"
Both Channel Power (CP) and Adjacent-Channel Power (ACLR) measurements are
available.
The remote commands required to perform these tasks are described in Chapter 8.6.3,
"Measuring the Channel Power and ACLR", on page 542.
● General CP/ACLR Measurement Settings............................................................262
● Channel Setup...................................................................................................... 267
General CP/ACLR Measurement Settings
General measurement settings are defined in the "ACLR Setup" dialog, in the "General
Settings" tab.
Measurements and Results