User Manual

The Spectrum Application (RF Measurements)
R&S
®
FPL1000
279User Manual 1178.3370.02 ─ 03
Remote command:
You can also query the determined carrier-to-noise ratio via the remote command
CALC:MARK:FUNC:POW:RES? CN or CALC:MARK:FUNC:POW:RES? CN0, see
CALCulate<n>:MARKer<m>:FUNCtion:POWer<sb>:RESult? on page 538.
7.2.4.3 Carrier-to-Noise Configuration
Access: "Overview" > "Select Measurement" > "C/N" / "C/N0" > "Carrier Noise Config"
Both a carrier-to-noise ratio (C/N) and a carrier-to-noise ratio in relation to the band-
width (C/N
0
) measurement are available.
Carrier-to-noise measurements are not available in zero span mode.
The easiest way to configure a measurement is using the configuration "Overview" ,
see Chapter 7.1, "Configuration Overview", on page 230.
The remote commands required to perform these tasks are described in Chapter 8.6.4,
"Measuring the Carrier-to-Noise Ratio", on page 559.
Measurements and Results