User Manual

The Spectrum Application (RF Measurements)

R&S

FPL1000

308User Manual 1178.3370.02 ─ 03

Sub Block Count ........................................................................................................ 308

Sub Block / Center Freq .............................................................................................308

Standard .....................................................................................................................308

Edit Sweep List .......................................................................................................... 308

Sub Block Count

Defines the number of sub blocks. By default, the familiar SEM measurement with just

one single block of ranges is configured.

Remote command:

[SENSe:]ESPectrum<sb>:SCOunt on page 565

Sub Block / Center Freq

Defines the center frequency for an individual sub block. The center frequency deter-

mines the reference range used for each block.

For measurements with only one sub block, this setting corresponds to the global set-

ting in the "Frequency" settings (see Center Frequency ).

Remote command:

[SENSe:]ESPectrum<sb>:SCENter on page 564

Standard

Defines the use of a standard settings file for a particular sub block. For details, see

"Standard Files" on page 311.

Remote command:

[SENSe:]ESPectrum<sb>:PRESet[:STANdard] on page 562

Edit Sweep List

Switches to the "Sweep List" tab of the "Spectrum Emission Mask" dialog box to con-

figure the individual frequency ranges and mask limits for the corresponding sub block.

See " Sweep List " on page 302.

Reference Range

Access: "Overview" > "Select Measurement" > "Spectrum Emission Mask" > "Refer-

ence Range"

The range around the center frequency is defined as the reference range for all other

ranges in the sweep list.

Measurements and Results