User Manual

The Spectrum Application (RF Measurements)
R&S
®
FPL1000
334User Manual 1178.3370.02 ─ 03
Remote command:
[SENSe:]LIST:RANGe<range>:RLEVel on page 596
RF Attenuation Mode
Activates or deactivates the auto mode for RF attenuation.
For details on attenuation, see Chapter 7.5.1.2, "RF Attenuation", on page 383.
Remote command:
[SENSe:]LIST:RANGe<range>:INPut:ATTenuation:AUTO on page 595
RF Attenuation
Sets the attenuation value for that range.
Remote command:
[SENSe:]LIST:RANGe<range>:INPut:ATTenuation on page 594
Preamp
Switches the preamplifier on or off.
For details on the preamplifier, see " Preamplifier " on page 387.
Remote command:
[SENSe:]LIST:RANGe<range>:INPut:GAIN:STATe on page 595
Sweep Points
Sets the number of sweep points for the specified range.
For details on sweep points, see Chapter 7.6.1.8, "How Much Data is Measured:
Sweep Points and Sweep Count", on page 395.
Remote command:
[SENSe:]LIST:RANGe<range>:POINts[:VALue] on page 596
Stop After Sweep
This function is not available for the R&S FPL1000.
Transducer
Sets a transducer for the specified range. You can only choose a transducer that fulfills
the following conditions:
●
The transducer overlaps or equals the span of the range.
●
The x-axis is linear.
●
The unit is dB.
For details on transducers, see Chapter 6.3.6.1, "Basics on Transducer Factors",
on page 147.
Remote command:
[SENSe:]LIST:RANGe<range>:TRANsducer on page 597
Limit Check
Activates or deactivates the limit check for all ranges.
For details on limit checks, see "Limit Lines in Spurious Measurements" on page 330.
"ABSOLUTE"
Signal is checked against absolute limit values
"NONE"
No limit check is performed.
Measurements and Results