User Manual

The Spectrum Application (RF Measurements)
R&S
®
FPL1000
470User Manual 1178.3370.02 ─ 03
Function Trace Settings
Set Trace Mode
Max | ClrWrite | Min
Trace 1: Max Hold
Auto Detector (Positive Peak)
Trace 2: Clear Write
Auto Detector (Auto Peak)
Trace 3: Min Hold
Auto Detector (Negative Peak)
Traces 4-6: Blank
Auto Detector
Trace 1 / Trace 2 / Trace 3 / Trace 4 (Softkeys)
Displays the "Traces" settings and focuses the "Mode" list for the selected trace.
For details see Chapter 7.10.1.3, "How to Configure a Standard Trace", on page 470.
Remote command:
DISPlay[:WINDow<n>]:TRACe<t>[:STATe] on page 689
Copy Trace
Access: "Overview" > "Analysis" > "Traces" > "Copy Trace"
Or: TRACE > "Copy Trace"
Copies trace data to another trace.
The first group of buttons (labeled "Trace 1" to "Trace 6" ) selects the source trace. The
second group of buttons (labeled "Copy to Trace 1" to "Copy to Tace 6" ) selects the
destination.
Remote command:
TRACe<n>:COPY on page 693
7.10.1.3 How to Configure a Standard Trace
Step-by-step instructions on configuring the trace settings are provided here.
For details on individual functions and settings see Chapter 7.10.1.2, "Trace Settings",
on page 466.
The remote commands required to perform these tasks are described in Chapter 8.8.7,
"Configuring the Trace Display and Retrieving Trace Data", on page 687.
Trace settings are configured in the "Traces" dialog box.
To display the "Traces" dialog box, do one of the following:
●
Press the TRACE key and then select the "Trace Config" softkey.
●
Select "Analysis" from the "Overview" , then select the "Traces" tab.
1. For each trace, select the "Trace Mode" and "Trace Detector" . Traces with the
trace mode "Blank" are not displayed.
Trace Configuration