User Manual

The Spectrum Application (RF Measurements)
R&S
®
FPL1000
501User Manual 1178.3370.02 ─ 03
Remote command:
CALCulate<n>:LIMit<k>:CONTrol[:DATA] on page 770
CALCulate<n>:LIMit<k>:LOWer[:DATA] on page 772
CALCulate<n>:LIMit<k>:UPPer[:DATA] on page 776
Insert Value
Inserts a data point in the limit line above the selected one in the "Edit Limit Line" dia-
log box.
Delete Value
Deletes the selected data point in the "Edit Limit Line" dialog box.
Shift x
Shifts the x-value of each data point horizontally by the defined shift width (as opposed
to an additive offset defined for the entire limit line, see " X-Offset " on page 497).
Remote command:
CALCulate<n>:LIMit<k>:CONTrol:SHIFt on page 772
Shift y
Shifts the y-value of each data point vertically by the defined shift width (as opposed to
an additive offset defined for the entire limit line, see " Y-Offset " on page 498).
Remote command:
CALCulate<n>:LIMit<k>:LOWer:SHIFt on page 774
CALCulate<n>:LIMit<k>:UPPer:SHIFt on page 777
Save
Saves the currently edited limit line under the name defined in the "Name" field.
Import
Opens a file selection dialog box and loads the limit line from the selected file in .CSV
format.
Note that a valid import file must contain a minimum of required information for the
R&S FPL1000.
For details on the file format see Chapter 7.11.2.4, "Reference: Limit Line File Format",
on page 506.
Remote command:
MMEMory:LOAD<n>:LIMit on page 781
Export
Opens a file selection dialog box and stores the currently displayed limit line to the
defined file in .CSV format.
For details on the file format see Chapter 7.11.2.4, "Reference: Limit Line File Format",
on page 506.
The limit line can be imported again later by the R&S FPL1000 for use in other mea-
surements.
Remote command:
MMEMory:STORe<n>:LIMit on page 781
Display and Limit Lines