User Manual

Remote Commands
R&S
®
FPL1000
529User Manual 1178.3370.02 ─ 03
Table 8-2: Available channel setup types and default channel setup names
Application <ChannelType> Parameter Default Channel Setup Name*)
Spectrum SANALYZER Spectrum
Analog Demodulation ADEM Analog Demod
I/Q Analyzer IQ IQ Analyzer
Noise Figure Measure-
ments
NOISE Noise
Note: the default channel setup name is also listed in the table. If the specified name for a new channel
setup already exists, the default name, extended by a sequential number, is used for the new channel
setup.
INSTrument:REName <ChannelName1>, <ChannelName2>
This command renames a channel setup.
Parameters:
<ChannelName1> String containing the name of the channel setup you want to
rename.
<ChannelName2> String containing the new channel setup name.
Note that you cannot assign an existing channel setup name to
a new channel setup; this will cause an error.
Usage: Setting only
Manual operation: See "Changing the Channel Setup Name" on page 66
INSTrument[:SELect] <ChannelType> | <ChannelName>
This command activates a new channel setup with the defined channel setup type, or
selects an existing channel setup with the specified name.
Also see
●
INSTrument:CREate[:NEW] on page 527
Parameters:
<ChannelType> Channel type of the new channel setup.
For a list of available channel setup types see INSTrument:
LIST? on page 528.
<ChannelName> String containing the name of the channel setup.
Example:
INST IQ
INST 'MyIQSpectrum'
Selects the channel setup named 'MyIQSpectrum' (for example
before executing further commands for that channel setup).
Selecting the Operating Mode and Application