User Manual

Remote Commands
R&S
®
FPL1000
534User Manual 1178.3370.02 ─ 03
INITiate:SEQuencer:MODE SINGle
//Sweep all channels once, taking the sweep count in each channel into account
INITiate:SEQuencer:IMMediate;*OPC?
//Set marker to maximum in IQ1 and query result
CALCulate:MARKer:MAXimum
CALC:MARK:Y?
//Switch to second IQ channel and retrieve results
INST:SEL 'IQ 2';*WAI
CALCulate:MARKer:MIN
CALC:MARK:Y?
//Switch to first Spectrum channel
INST:SEL 'Spectrum';*WAI
//Query one of the SEM results
CALCulate:MARKer:FUNCtion:POWer:RESult? CPOWer
//Switch to second Spectrum channel
INST:SEL 'Spectrum 2';*WAI
//Query channel power result
CALCulate:MARKer:FUNCtion:POWer:RESult? ACPower
8.6 Configuring and Performing Measurements
The following commands are required to configure measurements in a remote environ-
ment. The tasks for manual operation are described in Chapter 7.2, "Measurements
and Results", on page 232.
● Performing Measurements....................................................................................534
● Configuring Power Measurements........................................................................537
● Measuring the Channel Power and ACLR............................................................ 542
● Measuring the Carrier-to-Noise Ratio................................................................... 559
● Measuring the Occupied Bandwidth..................................................................... 560
● Measuring the Spectrum Emission Mask..............................................................561
● Measuring Spurious Emissions.............................................................................590
● Measuring the Time Domain Power......................................................................602
● Measuring the Harmonic Distortion.......................................................................612
● Measuring the Third Order Intercept Point............................................................616
● Measuring the AM Modulation Depth....................................................................618
● List Evaluations.....................................................................................................620
● Measuring the Pulse Power.................................................................................. 624
● Programming Example: Performing a Basic Frequency Sweep........................... 629
8.6.1 Performing Measurements
Useful commands for performing measurements described elsewhere
●
INITiate<n>:ESPectrum on page 564
●
INITiate<n>:SPURious on page 591
Configuring and Performing Measurements