User Manual

Remote Commands
R&S
®
FPL1000
538User Manual 1178.3370.02 ─ 03
Parameters:
<Mode> WRITe
The power is calculated from the current trace.
MAXHold
The power is calculated from the current trace and compared
with the previous power value using a maximum algorithm.
Manual operation: See " Power Mode " on page 266
CALCulate<n>:MARKer<m>:FUNCtion:POWer<sb>:RESult? <Measurement>
This command queries the results of power measurements.
To get a valid result, you have to perform a complete measurement with synchroniza-
tion to the end of the measurement before reading out the result. This is only possible
for single sweep mode.
See also INITiate<n>:CONTinuous on page 536.
Suffix:
<n>, <m>
.
irrelevant
<sb> 1 | 2 | 3 (4 | 5)
Multi-SEM: 1 to 3
for all other measurements: irrelevant
Configuring and Performing Measurements