User Manual

Remote Commands
R&S
®
FPL1000
545User Manual 1178.3370.02 ─ 03
If you set the channel bandwidth for the first alternate channel, the R&S FPL1000 sets
the bandwidth of the other alternate channels to the same value, but not the other way
round. The command works hierarchically: to set a bandwidth of the 3rd and 4th chan-
nel, you have to set the bandwidth of the 3rd channel first.
Suffix:
<ch>
.
1 to 11
Alternate channel number
Parameters:
<Bandwidth> Range: 100 Hz to 1000 MHz
*RST: 14 kHz
Manual operation: See " Channel Bandwidth " on page 267
[SENSe:]POWer:ACHannel:BWIDth[:CHANnel<ch>]
<Bandwidth>
[SENSe:]POWer:ACHannel:BANDwidth[:CHANnel<ch>] <Bandwidth>
This command defines the channel bandwidth of the transmission channels.
Suffix:
<ch>
.
1 to 18
Tx channel number
Parameters:
<Bandwidth> Range: 100 Hz to 1000 MHz
*RST: 14 kHz
Manual operation: See " Channel Bandwidth " on page 267
See " Channel Bandwidth " on page 280
See " Channel Bandwidth " on page 285
[SENSe:]POWer:ACHannel:NAME:ACHannel <Name>
This command defines a name for the adjacent channel.
Parameters:
<Name> String containing the name of the channel
*RST: ADJ
Manual operation: See " Channel Names " on page 269
[SENSe:]POWer:ACHannel:NAME:ALTernate<ch> <Name>
This command defines a name for an alternate channel.
Suffix:
<ch>
.
1 to 11
Alternate channel number
Parameters:
<Name> String containing the name of the channel
*RST: ALT<1...11>
Configuring and Performing Measurements