User Manual

Remote Commands
R&S
®
FPL1000
560User Manual 1178.3370.02 ─ 03
//Initiates a new measurement and waits until the sweep has finished.
//---------------Retrieving Results-------------
CALC:MARK:FUNC:POW:RES? CN
//Returns the carrier-to-noise ratio.
8.6.5 Measuring the Occupied Bandwidth
All remote control commands specific to occupied bandwidth measurements are
described here.
● Configuring the Measurement...............................................................................560
● Programming Example: OBW Measurement........................................................561
8.6.5.1 Configuring the Measurement
The following commands configure measurements of the occupied bandwidth.
Useful commands for occupied bandwidth measurements described elsewhere
Configuring the channel:
●
[SENSe:]POWer:ACHannel:BANDwidth[:CHANnel<ch>]
●
[SENSe:]POWer:ACHannel:PRESet
●
[SENSe:]POWer:ACHannel:PRESet:RLEVel
Defining search limits:
●
CALCulate<n>:MARKer<m>:X:SLIMits[:STATe] on page 717
●
CALCulate<n>:MARKer<m>:X:SLIMits:LEFT on page 717
●
CALCulate<n>:MARKer<m>:X:SLIMits:RIGHt on page 717
Performing the measurement:
●
CALCulate<n>:MARKer<m>:FUNCtion:POWer:SELect on page 540
●
CALCulate<n>:MARKer<m>:FUNCtion:POWer[:STATe] on page 540
Retrieving results:
●
CALCulate<n>:MARKer<m>:FUNCtion:POWer<sb>:RESult? on page 538
Remote commands exclusive to occupied bandwidth measurements:
[SENSe:]POWer:BWIDth................................................................................................ 560
[SENSe:]POWer:BANDwidth...........................................................................................560
[SENSe:]POWer:BWIDth <Percentage>
[SENSe:]POWer:BANDwidth <Percentage>
This command selects the percentage of the total power that defines the occupied
bandwidth.
Configuring and Performing Measurements