User Manual

Remote Commands
R&S
®
FPL1000
562User Manual 1178.3370.02 ─ 03
See also Chapter 8.6.2, "Configuring Power Measurements", on page 537.
● Managing Measurement Configurations............................................................... 562
● Controlling the Measurement................................................................................563
● Configuring a Multi-SEM Measurement................................................................ 564
● Configuring a Sweep List...................................................................................... 565
● Configuring the Reference Range.........................................................................578
● Configuring the Power Classes.............................................................................580
● Configuring the List Evaluation............................................................................. 585
● Performing an SEM Measurement........................................................................587
● Retrieving Results.................................................................................................587
● Example: SEM Measurement............................................................................... 587
8.6.6.1 Managing Measurement Configurations
The following commands control measurement configurations for SEM measurements.
CALCulate<n>:LIMit<k>:ESPectrum<sb>:RESTore...........................................................562
[SENSe:]ESPectrum<sb>:PRESet[:STANdard]................................................................. 562
[SENSe:]ESPectrum<sb>:PRESet:RESTore.....................................................................563
[SENSe:]ESPectrum<sb>:PRESet:STORe....................................................................... 563
CALCulate<n>:LIMit<k>:ESPectrum<sb>:RESTore
This command restores the predefined limit lines for the selected Spectrum Emission
Mask standard.
All modifications made to the predefined limit lines are lost and the factory-set values
are restored.
Suffix:
<n>, <k>, <sb>
.
irrelevant
Example:
CALC:LIM:ESP:REST
Resets the limit lines for the current Spectrum Emission Mask
standard to the default setting.
[SENSe:]ESPectrum<sb>:PRESet[:STANdard] <Standard>
This command loads a measurement configuration.
Standard definitions are stored in an xml file. The default directory for SEM standards
is C:\Users\Public\Documents\Rohde-Schwarz\Analyzer\sem_std.
Suffix:
<sb>
.
1 | 2 | 3
Sub block in a Multi-SEM measurement
Configuring and Performing Measurements