User Manual

ManualsBrandsRohde & Schwarz ManualsSignal Generators & Spectrum AnalysersSpectrum Analyser Full Package, 3GHz, 50Ohm

561

562

563

564

565

566

567

568

569

570

Remote Commands

R&S

FPL1000

565User Manual 1178.3370.02 ─ 03

Suffix:

<sb>

1 | 2 | 3

Sub block in a Multi-SEM measurement

Parameters:

<Frequency> Frequency within the currently defined global span (see

[SENSe:]FREQuency:SPAN on page 644 and [SENSe:

]FREQuency:CENTer on page 642).

Range: 1 to 3

*RST: 1

Example:

ESP1:SCEN 1GHZ

Manual operation: See " Sub Block / Center Freq " on page 308

[SENSe:]ESPectrum<sb>:SBCount <SubBlocks>

[SENSe:]ESPectrum<sb>:SCOunt <SubBlocks>

This command defines the number of sub blocks in the SEM measurement. (<sb> is

irrelevant)

Parameters:

<SubBlocks> Number of sub blocks in the SEM measurement.

Range: 1 to 3

*RST: 1

Example:

ESP:SCO 2

Manual operation: See " Sub Block Count " on page 308

8.6.6.4 Configuring a Sweep List

The following commands define a sweep list for SEM measurements.

The sweep list cannot be configured using remote commands during an on-going

sweep operation.

See also:

●

CALCulate<n>:LIMit<k>:ESPectrum<sb>:PCLass<PClass>:LIMit[:

STATe] on page 583

[SENSe:]ESPectrum<sb>:HighSPeed.............................................................................. 566

[SENSe:]ESPectrum<sb>:RANGe<range>:BANDwidth:RESolution.....................................566

[SENSe:]ESPectrum<sb>:RANGe<range>:BANDwidth:VIDeo............................................567

[SENSe:]ESPectrum<sb>:RANGe<range>:COUNt?.......................................................... 567

[SENSe:]ESPectrum<sb>:RANGe<range>:DELete............................................................567

[SENSe:]ESPectrum<sb>:RANGe<range>:FILTer:TYPE................................................... 568

[SENSe:]ESPectrum<sb>:RANGe<range>[:FREQuency]:STARt........................................ 568

[SENSe:]ESPectrum<sb>:RANGe<range>[:FREQuency]:STOP......................................... 568

[SENSe:]ESPectrum<sb>:RANGe<range>:INPut:ATTenuation...........................................569

[SENSe:]ESPectrum<sb>:RANGe<range>:INPut:ATTenuation:AUTO.................................569

Configuring and Performing Measurements