User Manual

ManualsBrandsRohde & Schwarz ManualsSignal Generators & Spectrum AnalysersSpectrum Analyser Full Package, 3GHz, 50Ohm

561

562

563

564

565

566

567

568

569

570

Remote Commands

R&S

FPL1000

566User Manual 1178.3370.02 ─ 03

[SENSe:]ESPectrum<sb>:RANGe<range>:INPut:GAIN:STATe.......................................... 570

[SENSe:]ESPectrum<sb>:RANGe<range>:INSert............................................................. 570

[SENSe:]ESPectrum<sb>:RANGe<range>:LIMit<PClass>:ABSolute:STARt........................ 570

[SENSe:]ESPectrum<sb>:RANGe<range>:LIMit<PClass>:ABSolute:STOP......................... 571

[SENSe:]ESPectrum<sb>:RANGe<range>:LIMit<PClass>:RELative:STARt.........................572

[SENSe:]ESPectrum<sb>:RANGe<range>:LIMit<PClass>:RELative:STARt:ABS................. 572

[SENSe:]ESPectrum<sb>:RANGe<range>:LIMit<PClass>:RELative:STARt:FUNCtion..........573

[SENSe:]ESPectrum<sb>:RANGe<range>:LIMit<PClass>:RELative:STOP......................... 573

[SENSe:]ESPectrum<sb>:RANGe<range>:LIMit<PClass>:RELative:STOP:ABS.................. 574

[SENSe:]ESPectrum<sb>:RANGe<range>:LIMit<PClass>:RELative:STOP:FUNCtion.......... 575

[SENSe:]ESPectrum<sb>:RANGe<range>:LIMit<PClass>:STATe...................................... 575

[SENSe:]ESPectrum<sb>:RANGe<range>:POINts:MINimum[:VALue].................................576

[SENSe:]ESPectrum<sb>:RANGe<range>:MLCalc........................................................... 576

[SENSe:]ESPectrum<sb>:RANGe<range>:RLEVel........................................................... 577

[SENSe:]ESPectrum<sb>:RANGe<range>:SWEep:TIME...................................................577

[SENSe:]ESPectrum<sb>:RANGe<range>:SWEep:TIME:AUTO.........................................578

[SENSe:]ESPectrum<sb>:RANGe<range>:TRANsducer....................................................578

[SENSe:]ESPectrum<sb>:HighSPeed <State>

This command turns high speed mode for SEM measurements on and off.

For more information including restrictions see "Fast SEM Measurements"

on page 296.

Suffix:

<sb>

1 | 2 | 3

Parameters:

<State> ON | OFF | 1 | 0

*RST: 0

Example:

ESP:HSP ON

Manual operation: See " Fast SEM " on page 303

[SENSe:]ESPectrum<sb>:RANGe<range>:BANDwidth:RESolution <RBW>

This command defines the resolution bandwidth for a SEM range.

In case of high speed measurements, the resolution bandwidth has to be identical for

all ranges.

Suffix:

<sb>

1 | 2 | 3

<range> 1...30

Selects the measurement range.

Configuring and Performing Measurements