User Manual

Remote Commands
R&S
®
FPL1000
585User Manual 1178.3370.02 ─ 03
●
The lower limit of a power class must always be the same as the upper limit of the
previous power class.
●
The power class must already exist (see CALCulate<n>:LIMit<k>:
ESPectrum<sb>:PCLass:COUNt on page 582).
Suffix:
<n>, <k>
.
irrelevant
<sb> 1 | 2 | 3
<PClass> 1...4
power class
Parameters:
<Level> Range: -200 dBm to 199.9 dBm
Example:
CALC:LIM:ESP:PCL2:MIN -40 dBm
Sets the minimum power value of the second power class to -40
dBm.
Manual operation: See " PMin / PMax " on page 311
8.6.6.7 Configuring the List Evaluation
The following commands configure the list evaluation.
Useful commands for SEM measurements described elsewhere
●
MMEMory:STORe<n>:LIST on page 812
Remote commands exclusive to SEM measurements
CALCulate<n>:ESPectrum:PSEarch:AUTO...................................................................... 585
CALCulate<n>:ESPectrum:PEAKsearch:AUTO.................................................................585
CALCulate<n>:ESPectrum:PSEarch[:IMMediate].............................................................. 586
CALCulate<n>:ESPectrum:PEAKsearch[:IMMediate].........................................................586
CALCulate<n>:ESPectrum:PSEarch:MARGin...................................................................586
CALCulate<n>:ESPectrum:PEAKsearch:MARGin............................................................. 586
CALCulate<n>:ESPectrum:PSEarch:PSHow.................................................................... 586
CALCulate<n>:ESPectrum:PEAKsearch:PSHow...............................................................586
CALCulate<n>:ESPectrum:PSEarch:AUTO <State>
CALCulate<n>:ESPectrum:PEAKsearch:AUTO <State>
This command turns the list evaluation on and off.
Suffix:
<n>
.
Window
<m> Marker
Parameters:
<State> ON | OFF | 0 | 1
*RST: 1
Configuring and Performing Measurements