User Manual

Remote Commands
R&S
®
FPL1000
587User Manual 1178.3370.02 ─ 03
Example:
CALC:ESP:PSE:PSH ON
Marks all peaks with blue squares.
Manual operation: See " Show Peaks " on page 314
See " Show Peaks " on page 336
8.6.6.8 Performing an SEM Measurement
The following commands are required to perform an SEM measurement:
●
SENS:SWE:MODE ESP, see [SENSe:]SWEep:MODE on page 564
●
INITiate<n>[:IMMediate] on page 536
8.6.6.9 Retrieving Results
The following commands analyze and retrieve measurement results for SEM measure-
ments.
●
TRACe<n>[:DATA] on page 703
●
TRACe<n>[:DATA]:MEMory? on page 704
●
TRACe<n>[:DATA]:X? on page 705
●
CALCulate<n>:MARKer<m>:FUNCtion:POWer<sb>:RESult? on page 538
8.6.6.10 Example: SEM Measurement
In this example we will configure and perform an SEM measurement. Note that this
example is primarily meant to demonstrate the remote control commands, it does not
necessarily reflect a useful measurement task. For most common measurement stand-
ards, the R&S FPL1000 performs the measurement optimally with the predefined set-
tings, without further configuration.
//-----------Preparing the measurement ------------
//Reset the instrument
*RST
//------------ Preparing the measurement------------
//Activate SEM Measurement
SWE:MODE ESP
//Selects single sweep mode.
//SEM has to be in single sweep mode to be configured and no sweep operation
//may be running!
// If required, a sweep stop can be ensured by INIT:IMM;*WAI
INIT:CONT OFF
//------------ Managing Measurement Configurations----------
//Load the 3GPP configuration stored in the file '3GPP_UL.xml'
ESP:PRES 'WCDMA\3GPP\UL\3GPP_UL.xml'
Configuring and Performing Measurements