User Manual

Remote Commands
R&S
®
FPL1000
597User Manual 1178.3370.02 ─ 03
Parameters:
<RefLevel> Reference level.
Refer to the data sheet for the reference level range.
*RST: 0 dBm
Manual operation: See " Reference Level " on page 333
[SENSe:]LIST:RANGe<range>:SWEep:TIME <SweepTime>
This command defines the sweep time for a spurious emission measurement range.
Suffix:
<range>
.
1..30
Selects the measurement range.
Parameters:
<SweepTime> Sweep time.
The range depends on the ratios of the span to the RBW and
the RBW to the VBW. Refer to the data sheet for more informa-
tion.
Manual operation: See " Sweep Time " on page 333
[SENSe:]LIST:RANGe<range>:SWEep:TIME:AUTO <State>
This command turns automatic selection of the sweep time for a spurious emission
measurement range on and off.
Suffix:
<range>
.
1..30
Selects the measurement range.
Parameters:
<State> ON | OFF | 0 | 1
*RST: 1
Manual operation: See " Sweep Time Mode " on page 333
[SENSe:]LIST:RANGe<range>:TRANsducer <Transducer>
This command selects a transducer factor for a spurious emission measurement
range.
Note that
●
the transducer must cover at least the span of the range
●
the x-axis has to be linear
●
the unit has to be dB
Suffix:
<range>
.
1..30
Selects the measurement range.
Configuring and Performing Measurements